Bindubba Sequencer - Eurorack version
This is a re-boot of the bindubba3 sequencer which was originally released in March 2010, tho there have been a few changes since that version. The bindubba3 has no software or microprocessors on board, it is all CMOS, op amps and vactrols.
It is designed to be used with the Divide & Conquer.
This sequencer has 6 inputs to control the stepping. Two clock inputs control the count in horizontal and vertical directions. The two jump inputs send the next step somewhere else that depends on the 2^2 and 2^3 counts of the chips of both step directions......ie somewhat uncontrollable but it enables more complex patterns to be created. The two direction inputs change the direction of the count.
There are two voltage controlled slewed outputs, two CV outputs giving the same CV, 1 inverted CV output and 16 gate outputs.
PCB = USD28
28HP panel = USD32
assembled = USD320
Build guide is HERE
Limited edition black panels. I had a few of these made as a special request. Be quick. sold out
It is designed to be used with the Divide & Conquer.
This sequencer has 6 inputs to control the stepping. Two clock inputs control the count in horizontal and vertical directions. The two jump inputs send the next step somewhere else that depends on the 2^2 and 2^3 counts of the chips of both step directions......ie somewhat uncontrollable but it enables more complex patterns to be created. The two direction inputs change the direction of the count.
There are two voltage controlled slewed outputs, two CV outputs giving the same CV, 1 inverted CV output and 16 gate outputs.
PCB = USD28
28HP panel = USD32
assembled = USD320
Build guide is HERE